More Filters
Parting out 1 used 15 to 17 trunklid..used Recently painted shadow black. Trunk lid had 6 holes from Anderson Composite spoiler which was removed. Asking $250 or best offer..$75.00 to ship or free to pickup.located Hampton, VA 23669.
Fits 2018 to 2021. Stock air intake. All pieces including filter. Asking $95.00 shipped. Came off my 2019.
1 gas pedal only.Used from a 2015 mustang GT. I replaced at about 6k. Easy bolt on With existing factory hardware. $50 shipped
Used air intake box and filter just taking space in my unit. Complete take off at about 6 k miles. Fits 15 to 17 GT.. asking $80 shipped. Or you can pickup Hampton, VA 23669.
passenger fender don't know the year but it's definitely from a 411
$50

Ghia Hood

Late ghia hood. Little crunchy in the corners on the windshield end but not terrible.
late square rear hatch fair to good condition
Late bay engine hatch. Some deep pitting in spots but no through rust that I could find.
Set of type 3 gauges Working condition unknown $40 plus shipping Payment by PayPal
jalousie windows for bay bus $200 for a pair no shipping
I had a local guy ask me to make a radio delete panel for his late Ghia and it came out nice enough I thought I'd make a few more. Not sure all the years it will fit but the opening was 1 3/4" x 7 1/8". Check the pictures to see if your dash looks the same. Made of aluminum and can be painted, brushed or polished. Held in with magnets so no changes to your dash are required and to reverse it yo...
CNC engraved / milled Karmann Ghia speaker cover plate; 1/4" thick aluminum, brush finish. Script with slots is $50 shipped All others are $45 shipped Rear is smooth so mounting should be a dob of glue or silicone in each corner. Not much is needed, just enough to keep it from bouncing out. Disclamers; This was designed to fit a '62 Ghia but I can't imagine the factory made new dies for the oth...
I made a set of manifold adapters to run carbs on my 1.9 in my 85 Vanagon. Made a spare set while I was at it. The bottoms match the vanagon spacer and the tops match the T1 standard flange. I have 50mm hardware that comes with it. You'd have to remove your old studs and install these. No gaskets included.
New Pagid brake set. Yellow fronts, black rear. Purchased for 997.2 C4S. Should also fit 987 S. Race, track, HPDE, TT
Bran new OMP seats and 6-pt OMP harnesses, both mounted on GMG sliders + Brey-Krause harness bar with brand new hardware. 1 - HTE-R (containment) 1 - CHAMP-R 6-pt OMP harnesses w/boxes GMG slider bases Brey-Krouse harness bar (no cutting interior trim or carpet required, simple 15-minute bolt-in) Test installed in my 997, but never driven/raced. I know it fits 997 and 987. Pretty sure 996 is th...
I have a couple NOS Carter accelerator pumps for the 125S carbs. This is the housing with piston and linkage on it. $50 ea. Email me for picture and info bwbugay@aol.com
I have a NOS carter accelerator pump housing with rubber boot and brass shaft ( NO piston ) for 1930-31 carter 136S and 150S carbs . $ 40. Email me for picture and more info. bwbugay@aol.com
Your Listing Here